Plextor M8PeY 1TB SSD Firmware 1.06
The Plextor M8PeY 1TB SSD Firmware version 1.06 is the latest firmware update for this high-performance SSD. This SSD provides incredible speed, reliability, and power efficiency with technology that is built from high-quality components. The M8PeY is easy to install and can be used on any desktop or laptop, making it an excellent choice for users who demand the ultimate performance for their tasks.
Features
- 1TB Capacity
- M.2 PCIe Gen 3 x4 Interface
- Sequential Read: Up to 2500 MB/s
- Sequential Write: Up to 1400 MB/s
- DRAM Cache 1GB DDR3
- Advanced wear leveling
- High-quality Toshiba memory components
- Supports TRIM and garbage collection
- ECC protection for everyday usage
- Heat Sink Included
Technologies
The Plextor M8PeY 1TB SSD Firmware version 1.06 utilizes the following technology:
- Toshiba MLC NAND flash memory
- Spider LED
- LDPC (Low-Density Parity Check) ECC
- NVMe 1.2 with PCI-Express Gen.3 x4
- Advanced Wear Leveling
- Perpendicularly Aligned Magnetics (PAM) Architecture
- Smart Burn Management
- Cache optimization
- Garbage Collection & Recovery
Known Issues:
The device is built with high quality components and therefore has minimal known issues that are easy to troubleshoot. However, users may experience some unexpected issues, such as:
- Incorrect BIOS setting or AHCI mode
- The presence of a security password that interferes with the software update.
Troubleshooting:
The following steps can be used to troubleshoot any issues related to the Plextor M8PeY 1TB SSD with Firmware 1.06:
- Ensure that your BIOS is up to date and that the SSD is set to AHCI mode
- Remove any security password utilities and software that is representative of the security measure
- Run Data Lifeguard Diagnostics on the drive to verify its health status
- Check the manufacturers site for the latest firmware available
- Schedule TRIM to run in the background of the OS
- Tweak the SATA driver's device performance settings if high write speeds environments are implemented.
Driver Information
The Plextor M8PeY 1TB SSD Firmware version 1.06 requires no driver installation thanks to the generic storage driver present in most modern operating systems.To ensure maximum compatibility with end user hardware, user referencers the updated storage controller drivers downloadable through the website.