Plextor M10PGN SSD Firmware 1.01
The Plextor M10PGN is the latest addition to Plextor’s M10P series. This firmware version 1.01 boasts faster read and write speeds and increased stability. With this drive, your computer will experience a speed boost in terms of responsiveness and load times, and have an increased durability.
Features
- Read speeds up to 560 MB/s, write speeds up to 540 MB/s
- Capacity: 256 GB
- 3 Year Warranty
- Increased durability due to the device's Stable Stream
- SMART monitoring suite, and Trim support
- M.2 PCIe NVMe interface helps with higher transfer speeds and power efficiency
Specifications
| Manufacturer: | Plextor |
|---|---|
| Storage Capacity: | 256 GB |
| Form Factor: | M.2 2280 |
| Interface: | PCI Express 3.0 x4 (NVMe) |
| Max Sequential Read Speed: | Up to 560 M |
| Max Sequential Write Speed: | Up to 540 MB/s |
| Dimensions (LxWxH): | 80.15 x 22.15 x 2.23 mm |
Technologies Used
The Plextor M10PGN SSD uses several cutting-edge technologies to achieve the results it offers:
- M.2 PCIe NVMe interface
- Toshiba 15nm Toggle NAND flash
- Extensive thermal throttling capabilities to protect SSD
- Eight-channel controller for even better performance
Known Issues and Troubleshooting
Some users have reported an issue with the M10PGN firmware where the drive would stop working entirely, shortly after the firmware has been updated. If this occurs you may need to try and reapply the firmware update or try re-flashing the drive.
If you are experiencing issues with your Plextor M10PGN SSD, there is a firmware download available on the Plextor website.
Driver Information
The Plextor M10PGN SSD does not require any additional drivers to work functionally . By using the standard NVMe drivers that came with your computer’s operating system , you will be ready to set up and use your newly installed SSD.